Frequent Asked Questions ... discover the SeaDek advantage!
Q. What is SeaDek?
A. SeaDek is manufactured in the United States from nonabsorbent, closed cell EVA foam specifically formulated for marine applications. Sports fishing, sailing, ski boats, commercial marine, platforms and steps are just a few of the unlimited applications for SeaDek Non-Skid Marine Traction.
SeaDek’s pressure sensitive adhesive backing makes application a breeze. Just measure, cut peel and stick. It’s that easy!
Q. How do I fit SeaDek?
A. SeaDek is applied using a peel and stick pressure sensitive adhesive specifically developed for the marine environment.
Q.What is the best method to clean SeaDek?
A. SeaDek cleans easilie with soap, water and a stiff brush.
Q. How do I cut SeaDek?
Use a fresh bladed razor knife.
A. What thickness do you recommend?
This depends on the end use. For cockpits, swim platforms, poling and casting platforms, we recommend the 5mm thickness.
Q. Can I get custom cut product?
A. Only if CAD drawings for each part are supplied, please contact us at 1300 732 383 and let us know your requirement.
Q. What is the largest size I can order?
A. 99 cm x 196 cm in sheet form.
Q. What is the life expectancy?
A. Five to seven years. Longer if the boat is stored inside.
Q. What is the warranty?
A. SeaDek marine products are warranted to be free from any defects at the time of purchase. The EVA has a limited warranty for 5 years. The PSA (adhesive) cannot be warranted due to many outside issues that may be present during installation.
Q. Can I get a custom sized helm pad?
A. Yes, provide dimentions and please contact us at 1300 732 383 and let us known your requirements.
Q. Can I get a logo on my custom helm pad?
A. It's possible, please provide artwork and contact us at 1300 732 383 to let us know your requirements.
Q. Can SeaDek sheets be seemed?
A. This is not recommended. Even with a very small shrink rate, a small gap between sheets will be present. We recommend leaving a one inch gap between panels.
Q. How long will it stayed adhered?
A. If proper prepping has been done, you can expect 5-7 years of life.
Q. Can it be re-adheared if necessary?
A. Yes, if the edge has slightly come up, use an acrylic based super glue. If the sheet has completely come up, you will have to clean the area thoroughly to remove any existing PSA (adhesive) and reapply another new sheet.
Q. If I choose to remove the pad how do I do this?
A. Use a plastic putty knife to get under one corner. Grip and pull off. If the EVA seems to be sticking and tearing, use the putty knife to jab the area. You may want to enlist another set of hands to assist. Once the entire pad is removed, there will be a small amount of PSA (adhesive) left on the surface. Soak with mineral spirits for 10 minutes, scrap with the plastic putty knife. Once the PSA has been removed, use acetone to remove the mineral spirits.
Q. How do I prep the surface?
A. Use an ammonia based window cleaner and a scotch brite pad to remove any dirt, sunscreen, wax. sweat, etc. Scrub well and let dry completely. If the boat is new, you should repeat several times as new boats have mold release that may hinder adhesion.
Q. How do I make patterns for my......swimplatform, poling or casting platform, cockpit etc.?
A. Determine the layout for your particular application. Tape plastic sheeting over the area and use a permanent marker to trace the pattern onto the plastic. Cut the plastic and tape to cardboard. Cut cardboard to fit. Place template in boat to determine fit.
80' Catamaran Fat Cat